GoPro Anti-Fog Inserts (GoPro OFFICIAL ACCESSORY)
- Inserts prevent fogging of lens in cold and humid environments
- Each insert lasts for approximately 4 uses
- Includes (12) Twelve Anti-Fog Inserts
Additional information
Specification: GoPro Anti-Fog Inserts (GoPro OFFICIAL ACCESSORY)
|
Cool Breeze – Uniform to Photographer –
I recently used it with a GoPro Hero 11 while snorkeling it worked great no fog inside the case or on camera. I was able to get one strip installed but had trouble adding anymore. The one seemed to work so no biggie.
素直なレビュアー –
とにかくハウジングの曇り止めは必須です。
これを使えば曇りは皆無ですね。
使いっきりでもそこそこの量が入っているのでリサイクル目的じゃなくてもそれなりだと思います。
純正ならではの安心感があります。
繰り返し4回まで使えるので内容量の4倍使える計算です。
ハウジングにぴったりの設計なので、何ら不安無く使えると思います。
jsc –
They seemed to have worked on my recent dives (30 feet and also 70-90 feet) in Key Largo as I had no issues with fogging on my Hero 3+ silver. I placed two along the bottom (no problem), but it was really hard to get the one into the side near the lens. I had to peel a few layers off to thin the pad. The videos I’d watched online made it seem like that side insert would go in easier so I’m not sure if maybe I bought the wrong ones for my GoPro model.
Francois Dugre –
Worked great, never had issues with fog just a bit pricey
Honey –
These insert really work! These small anti-fog inserts fit perfectly inside of my GoPro camera case and absorb any moisture that may buildup due to the small amount of heat from the camera. I usually use 2 inserts when I’m in hot environments that are also near water, such as the beach or river Kayaking! When they have made their maximum absorption, you can just dry them out in the oven for 5 minutes to reset them. This is an essential item for GoPro cameras as it takes the moisture and fog away from the lens allowing for a crystal clear picture every time. Both of my GoPro cases have several sets of these Anit-Fog inserts stashed in them. I never leave the house wtihout them. 10/10 must have
M Huston –
I use these for underwater shooting, in <40 deg F water temps and air temps and these work perfectly. Prior to using the inserts, I started having severe fogging issues inside the sealed GoPro housing when temps started dropping into the low 60s. These inserts do the trick and I use 3 at a time as recommended. I've baked and re-used them time and again and they last through multiple openings of the housing to change batteries/memory cards in the camera. The little humidity monitor car that comes with these is useless. If I went by it's indicator areas, my inserts would never be "active" and would never work. It's unnecessary and inaccurate.
WORD OF CAUTION: Make sure that the way you position the inserts does NOT touch/interfere with the seal around the door; AT ALL. If it does, adjust them until it doesn’t, because the case WILL leak (albeit slowly) otherwise and you will have fog (or water, if it’s bad).
Deny –
this item shows that you will receive 12 inserts. Im receiving only 6. I order a replacement and it also came with only 6
chicco –
non sono stato avvisato che il pacco era gia a destinazione,scoperto x caso visto il ritardo nella consegna
Josef Nikoloff –
I have not experienced any fogging or fitment issues using these with my GoPro Hero 3 Black in either its standard waterproof case or with the BacPac Extended Battery’s water proof case.
They are a bit pricey, but they are also reusable. $15 seems reasonable for authentic parts from the manufacturer, all things considered.No issues so far, will update if something arises.
Heather –
These worked great. After recently moving to florida I was having issues with going from being in the AC to the water. We went to the beach with the dogs a handful of times and my pictures are all fuzzy from the fog. I bought these because they were suggested to me and they are perfect. I know youre supposed to cook them after use to reuse but one day I just used the same one I had forgotten to take out the prior use…it still worked perfect. So excited I bought these.
LJR –
I do a lot of boating and the GoPro is ideal, however, the changing ambient temperatures on the water would cause the housing to fog up so I’d lose a lot of clear footage from time to time which was infuriating. I used these anti fog tabs for the first time yesterday and the results were perfect! No fogging whatsoever! I’ll be buying a store of these for sure!
Seymour Halpern –
The anti-fog insert package includes a sensor pad to let you know when the inserts need to be recharged. The little circle should be the same shade of blue as the reference strip. The sensor in my package was pink indicating the inserts need to be recharged. Recharging consists of putting them in the oven for 5 minutes at 300 degrees to remove the moisture. As they can be recharged 4 times that means I only have 75% of the expected life expectancy. I don’t expect to test these until my next SCUBA trip in May.
I’ll post back after that trip.
Rupeshwar S. –
runs perfect…